SEAL Image 410 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 15)

SET-UP AND OPERATION

TEMPERATURE SETTINGS

• Select the film(s) that you will use on the top (and

bottom) of the images.

• Check which temperature setting is recommended

for your SEAL

Brands material (see literature

enclosed in your material box).

• Refer to the Control Panel Diagram for information

on setting the temperature.

NOTE: If a process requires heat, turn ON the

heaters approximately 30 minutes before use to

ensure that the rollers are at the correct

operating temperature.

IMPORTANT! The main roller should be

down and turning to prevent uneven hot spots

on the roller. A stationary heated roller will

develop concentrated heat in one area, which

will damage the roller.

ROLLER NIP SETTINGS

Whenever you mount onto a board, etc., it is important

to adjust the rollers to create a gap nearly equal to the

thickness of the board being used. This is done so that

anything passing between the rollers will receive the

right amount of pressure.

Equivalent Press Measurements

Inches Metric (mm) Decimal

MAX 28.6 mm 1.125

1 25 mm 1.000

3/4 19 mm 0.75

1/2 13 mm 0.50

3/8 10 mm 0.375

1/4 6 mm 0.25

3/16 5 mm 0.1825

1/8 4 mm 0.125

1/16 2 mm 0.0625

0 0 0

HOW TO SET THE ROLLER NIP

• First, determine the thickness of the board that you

will use for mounting.

• Adjust the nip setting by pressing the UP or

DOWN arrow until the desired measurement

corresponds with the thickness of board being used.

• Lower the top roller once the nip setting is adjusted.

WARNING! Too much pressure can crush the

board being used and even damage the top and

bottom rollers. Normally, a press of .025”

(0.6mm) is sufficient.

Figure 6. Nip Adjustment Settings

BASIC STEPS TO FEEDING IMAGES

NOTE: For good results, the process requires

that the images be fed through correctly.

• Make sure the leading edge of each image is flat all

the way across or any wrinkles or creases in the

image will show when laminated – perhaps even

magnified.

• A straight leading edge will aid in feeding in the

image.

• Feed the image into the laminator ensuring that the

leading edge is parallel to the roller.

NOTE: Do not stop the motor while an image

is being finished as this can cause marks in the

output.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

SEAL Image 410 Anleitung zur Fehlerbehebung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Laminatoren SEAL Image 410