ProSEAL® 25 & ProSEAL® 44 Laminators ProSEAL® 25 & ProSEAL® 44 Laminators Owner’s Operation Manual
10MOUNTING USING A ProSEAL® MOUNTING BOARD USING A ProSEAL MOUNTING BOARD • Refer to the instruction sheet packed with each box of ProSEAL Mountin
11MOUNTING USING A ProSEAL® POUCH BOARD • Refer to the instruction sheet packed with each box of ProSEAL Pouch Boards for specific instructions on
12ENCAPSULATING USING A ProSEAL® FLEXIBLE POUCH WITH A ProSEAL® SLED 1. Refer to the instruction sheet packed with each box of ProSEAL Flexible Po
13CLEANING YOUR LAMINATOR CLEANING THE LAMINATOR CAUTION! Disconnect the laminator from the power supply before cleaning. • The laminator may be
14TROUBLESHOOTING GUIDE Problem Cause Solution The power LED does not come on, when the nip setting knob has been set to one of the nip set
15SPARE PARTS PART DESCRIPTION SPARE PART CODE SPARE PART CODE ProSEAL 25 ProSEAL 44 Top Cover SP 144-165 SP 144-164 Right-Hand Inter
16GLOSSARY OF TERMS Cleaning Board: Boards specifically designed to attract and capture any adhesive that may be clinging to the rollers. Cold Mod
17PROCESS APPLICATION NOTES ________________________________________ ________________________________________ _____________________________________
18TECHNICAL SPECIFICATIONS Mechanical Height 12” (305 mm) 12” (305 mm) Overall Width 40” (1016 mm) 58” (1473 mm) Depth 15” (380 mm)
19LIMITED WARRANTY SEAL® Graphics warrants to the original consumer purchaser that each new SEAL® Image® Laminator, which proves defective in mater
2TABLE OF CONT ENTS TABLE OF CONT ENTS...
20ProSEAL® CONTACT INFORMATION SEAL BRANDS TECHNICAL SERVICE SEAL BRANDS TECHNICAL SERVICE – EUROPE AND ASIA PACIFIC (For technical as
3INTRODUCTION Thank you for purchasing a ProSEAL® Laminator. We have designed the ProSEAL Laminator to give you years of reliable service. As you
4IMPORTANT SAFEGUARDS When using electrical appliances, basic precautions should always be taken to reduce the risk of electrical shock and injury
5INSTALLATION The ProSEAL 25 and ProSEAL 44 are professional laminators designed for ease of use. The process speed and temperature have been pr
6UNPACKING, SET-UP AND INSTALLATION 1. Open the box, and lift the machine out (at least two persons necessary!). Grasp the machine 8”-10” (200mm-
7CONTROL KNOB The Control Knob (see Figure 1) is located on the right hand side of the laminator and is operated from the front of the machine. T
8CONTROL PANEL The Control Panel (see Figure 2) is located on the front right of the machine and has three LED indicators. A diagram of the Contr
9CONTROL PANEL DIAGRAM LED INDICATOR DESIGN The LED indicators are designed to indicate the on/off status of power, heat, and roller direction. Ple
Kommentare zu diesen Handbüchern